Warping Systems MW700 / MW1000 Warping Machine

WARPING SYSTEMS
MW700 / MW1000

Electronically controlled warping machine for elastic and non-elastic yarns.

Very high motor torque and thread tension
Extremely high motor running torque even in the case of large beam diameters
High-precision, synchronisation during constant running, start-up and braking
Very short stopping times in the case of thread breakages (prevents broken thread ends from running onto the warp beam) as a result of the switching of the drive motors to generative operation and thus the use of all the kinetic energy as braking power

Siemens S7 control system
Powered lifting and lower device for the loading of the warp beam at ground level with adjustable end positions in line with warp beam dimensions
Powered setting of the thrust bearing for the rapid adjustment to differing warp beam widths
Pneumatic warp beam ejection
Expanding reed with a laying device with 9 segments in a zigzag pattern in the MW700 and 11 in the case of the MW1000
Adjustable reed changing device with a stroke of up to 30 mm
Leasing device
High-definition metre measurement with shift or day counter
Programmable warping speed graduation in line with beam start-up
Safety devices with safety protection switch

Thread tension control device with negatively driven evener rollers for non-elastic yarns
Preliminary drafter for elastic yarns
Width-adjustable contact device for constant pressure during warping; adjustments can be made during warping
Antistatic device with 2 rods
Wax or oil device
Remote control
Warping machine mounted on rollers
Load measurement beam for the detection and regulation of thread tension

Models	MW700	MW1000
Maximum flange diameter [mm]	600	1000
Maximum beam length [mm]	700	1000
Maximum warping speed [m/min]
non-elastic	800	800
elastic	450	450

Positive driven pre-stretcher and roll-off creel for elastic yarns
Thread tension compensation rollers for non-elastic yarns